We have developed a new drill template, but our instructional videos have not yet been updated.
Below, you will find a description of how to use the drill template.
Hole Pattern 1 – Used for hinge plate without frame.
Place the drill template against the cabinet top rail and mark the drilling points with a pencil, or drill directly through the template using a 2 mm drill bit.
Repeat the same procedure by placing the template against the bottom panel.
Hole Pattern 2 – Used for drawer front for a 200 mm drawer.
Note that the angle of the drill template must not be oriented toward the corner of the drawer.
Mark the drilling point with a pencil and then drill using a 4 mm drill bit.
Hole Pattern 3 – Used for drawer front for a 100 mm drawer.
Note that the angle of the drill template must not be oriented toward the corner of the drawer.
Mark the drilling point with a pencil and then drill using a 4 mm drill bit.
Hole Pattern 4 – Used for frame clips.
Mark the drilling point with a pencil or drill directly through the template using a 2 mm drill bit.
Note: Hold the drill template on the wide side, not on the angled corner of the template.
Hole Pattern 5 – Used for decorative hinges.
Mark the drilling point at the desired height with a pencil or drill directly through the template using a 2mm drill bit.
To position the drawer front at the correct height on the drawer, use the angled corner of the drill template as a reference.
Instructions for Drill Template and Hole Patterns 2
Hole Pattern 1 – Used for a hinge plate without a frame. Place the drill template against the top rail of the cabinet and mark the drilling points with a pencil or drill directly through the template using a 2 mm drill bit. Then, repeat the same step by placing the template against the bottom panel.
Hole Pattern 2 – Used for a hinge plate with a frame. Place the drill template against the top rail of the cabinet and mark the drilling points with a pencil or drill directly through the template using a 2 mm drill bit. Then, repeat the same step by placing the template against the bottom panel.
Hole Pattern 3 – Used for a drawer front for a 100 mm drawer. Ensure that the angle of the drill template is not directed towards the drawer corner. Mark the drilling point with a pencil and then drill using a 4 mm drill bit.
Hole Pattern 4 – Used for a drawer front for a 200 mm drawer. Ensure that the angle of the drill template is not directed towards the drawer corner. Mark the drilling point with a pencil and then drill using a 4 mm drill bit.
Hole Pattern S-click – Used for a frame click. Mark the drilling point with a pencil or drill directly through the template using a 2 mm drill bit.
Hole Pattern Duomatic – Used for a hinge plate for concealed hinges. Place the drill template against the top rail of the cabinet and mark the drilling points with a pencil or drill directly through the template
using a 2 mm drill bit. Then, repeat the same step by placing the template against the bottom panel.
To position the drawer front at the correct height on the drawer, the drilling template’s angle is used.
