The cabinet with Pelly pull-out system is assembled according to the same principle as “CABINETS”.
• Open the drawer with the Pelly pull-out system and read the installation instructions.
• Install the supplied drawer runners on the right and left sides of the cabinet. Only one hole is pre-drilled in the cabinet for the system screw; the other two holes must be drilled during installation. Use a 4.5 mm drill bit. A routed line in the cabinet side is provided to assist with horizontal drilling.
• Install the Pelly guide block into the pre-drilled holes in the bottom panel.
• Assemble the side panels to the bottom panel using 4 wood screws, 4.0 × 35 mm.
• Attach two (or four, if space allows) plinth legs using 4.0 × 40 mm wood screws. For inset plinths with a lip, the plinth legs must be positioned 90 mm from the front edge (measured without the frame).
• Install the back panel, ensuring that it is pressed fully down into the groove in the bottom panel.
• Install the top rails at the back and front edges. Use 4.0 × 35 mm wood screws (4 screws per rail).
• Fasten the frame clips using 3.5 × 15 mm pan head screws (1 screw per frame clip).
Note: New drill template – read “DRILL TEMPLATE” before installation.
• Install the wall rail onto the wall. Use wood screws of a suitable length depending on the wall material (screws not included).
• Attach the mounting rail to the back of the cabinet using 4.5 × 25 mm wood screws (2 pcs).
• Attach the frames to the cabinet.
• Assemble the Pelly pull-out system with the shelves at the desired height according to the manufacturer’s installation instructions.
• Fasten the mounting brackets into the pre-drilled holes on the back of the front panel and attach the Pelly pull-out system.
• Install the pull-out unit into the cabinet and fine-adjust the front position according to the adjustment instructions provided by the manufacturer.
